International Journal
| 4 | M. Mashud. A.Al.- bAri and G. Kader, "Experimental Investigation of Drag Force Reduction Mechanism for Flow Around a Circular Cylinder ", International Journal of Engineering & Applied Science (IJEAS), IJEAS, vol. 3, issue 2, pp. 69-75, 29 January 2011. |
| 3 | Mohammad Mashud, Md. Golam kader, Akirm Umemurea, "Wing Cell Geometry And Pressure Distribution Over The Surface of A Paraglider", AARJMD, A Peer Reviewed International Journal of Asian Academic Research Associates, AARJMD Asian Academic Research Journal of Multidisciplinary, vol. 1, issue 13, Sep 2013. |
| 2 | Md. Golam kader, Mohammad Mashud, Maruf Hasan Rakib, "Effect of Nominal Diameter And Nozzle To Throat Area Ration on Suction Lift of Water Jet Pumps", AARJMD, A Peer Reviewed International Journal of Asian Academic Research Associates , vol. 1, issue 13, Sep 2013. |
| 1 | Md. Shahidul Islam, Md. Golam Kader, Md. Kamal Uddin and Mohiuddin Ahmed, "Analysis of Order of Singularity at a Vertex in 3D Transversely Isortipic Piezoelectric Single-Step Bonded Joints", American Journal of Engineering Research (AJER) e-ISSN:L 2320-0847, p-ISSN: 2320-0936, www.ajers.org, vol. 02, issue 09, pp. 87-99, 2013, USA. |
International Conference
| 7 | Kader, M.G. & Hossain, K.A., "Effect of Surface Roughness on Wall Jet", 2nd International Energy Conversion Engineering Conference, Providence, Rhode Island, USA, 16-19 August 2004. |
| 6 | M. Mashud, G. Kader and T. Miyasaka, "Numerical Performance Analysis of Pulse Detonation Engine", 3rd International conference and 8th Annual paper meet., IEB, Bangladesh, pp.77-80, 2003. |
| 5 | M. Mashud, G. Kader and T. Miyasaka, "Detonation Propagation in variable cross section Channels", 3rd International conference and 8th Annual paper meet. , IEB, Bangladesh, pp.57-60, 2003 |
| 4 | Md. Golam Kader, Md. Mizanur Rahman, Dr. Nawsher Ali Moaral and Dr. A.N.M. Mizanur Rahman, "Improved biomass briquetteing technology for reducing environment pollution", Proceeding of the 2nd Regional Conference on Energy Technology Towards a Clean Environment, Phuket, Thailand, 2003. |
| 3 | Md. Golam Kader, "Study of Compressed Natural gas vehicales and the potentiality of using compressed natural gas as a fuel in Bangladesh.", 2nd International Conference and 7th Annual Paper Meet. , IEB, Bangladesh, pp.110-117, 2002 |
| 2 | Md. Shahadot Hosen, A.S.M. Tanvir, Md. Golam Kader, "Improved Automobile Emission Purification System By Designing Modified Catalytic Converter", Proceeding of the international conference on Mechanical engineering and Reneable energy , ICMERE 2011, Chittagong, Banglade, December 2011. |
| 1 | Muhtasim Zarif Siraj , Md. Golam Kader, "Design and Construction of an Automatic Gas Welding System", 3rd International Conference on Mechanical, Industrial and Energy Engineering ICMIEE, Khulna, Bangladesh, December, 2014. |
National Journal
| 2 | Md. Shahidul Islam, Md. Golam Kader, M.M. Kamal Uddin and Mohiuddin Ahmed, "Analysis of order of Stress Singularity at a Vertex in 3D Transversely Isotropic Piezoelectric Dissimilar Bonded Joint", IEB, Bangladesh, vol. 44, 2014. |
| 1 | Md. Golam Kader, Khandkar Aftab Hossain, "Free convective Heat transfer from an object at low Rayleigh number", Journal of Mechanical Engineering , IEB, Bangladesh, vol. 43, issue 1, 2013. |
National Conference
| 4 | Md. Golam Kader M.M.A Hayder, M.M. Rahman and M.S. Islam, "Suitable Raw material for Briquette in Bangladesh", Department of Mechanical Engineering, BIT, Khulna, Bangladesh and AIT, Bangkok, Thailand , Seminar of URERAB, Bangladesh, 2001. |
| 3 | Md. Kutub Uddin and Md. Golam Kader, "Determination of Optimum Number of Manpower - A case study", Fourth Annual Paper Meet, IEB, Bangladesh, pp.250-253, 1997. |
| 2 | Md. Kutub Uddin and Md. Golam Kader, "Planning for Preventive Maintenance - A case study", Fourth Annual Paper Meet, IEB, Bangladesh, pp.266-271, 1997. |
| 1 | Md. Golam Kader, "Prospect of Energy Conservation - A case study", First Annual Paper Meet , IEB, Bangladesh, pp.266-271, 1994 |