Dr. Md. Hasan Ali
Professor
Department of Energy Science and Engineering
Khulna University of Engineering & Technology (KUET)
Khulna -9203, Bangladesh. Phone: +88041769468-75, Ext. 8481
Cell: +8801643763325, Mail : [email protected]
Website : www.kuet.ac.bd/et/hasan/

National/International Journal

(Selected Papers)

14 Nahyan Ahnaf Pratik, Md. Hasan Ali, Nafisa Lubaba, Nahid Hasan, Md. Asaduzzaman, Akio Miyara; "Numerical investigation to optimize the modified cavity receiver for enhancement of thermal performance of solar parabolic dish collector system". Energy, Volume 290, 2024, ID: 130133, Impacr Factor: 9.0. https://doi.org/10.1016/j.energy.2023.130133.
13 Shuvo Paul, Nafisa Lubaba, Nahyan Ahnaf Pratik, Md. Hasan Ali, Md. Mahmodul Alam; “Computational investigation of cross flow heat exchanger: A study for performance enhancement using spherical dimples on fin surface”. International Journal of Thermofluids, 2023, Volume 20, ID: 100483, https://doi.org/10.1016/j.ijft.2023.100483.
12 Rafiqul Islam, Md Hasan Ali, Nahyan Ahnaf Pratik, Nafisa Lubaba, Akio Miyara; “Numerical analysis of a flat plate collector using different types of parallel tube geometry”. AIP Advances, 2023; 13 (10): 105313. https://doi.org/10.1063/5.0159916
11 Md. Asaduzzaman, Md. Hasan Ali, Nahyan Ahnaf Pratik, Nafisa Lubaba; “Exhaust heat harvesting of automotive engine using thermoelectric generation technology”. Energy Conversion and Management: X, 2023, Volume 19, ID: 100398, https://doi.org/10.1016/j.ecmx.2023.100398.
10 Md Hasan Ali, Md Nawsher Ali Moral; “Pyrolytic fuel extraction from tire and tube: Analysis of parameters on product yield”. Case Studies in Chemical and Environmental Engineering, 2022, Volume 6, ID: 100273, https://doi.org/10.1016/j.cscee.2022.100273.
9 Md. Hasan Ali, and Akio Miyara, “Analysis of optimum slinky loop arrangement for horizontal ground heat exchanger” Transactions of the Japan Society of Refrigerating and Air Conditioning Engineers, 2017, Vol. 34, No. 4, pp. 473-483. https://doi.org/10.11322/tjsrae.17-55HE.
8 Md. Hasan Ali, Keishi Kariya, and Akio Miyara, “Performance analysis of slinky horizontal ground heat exchangers for a ground source heat pump system”, Resources, 2017, Vol. 6 (4), No. 56. https://doi.org/10.3390/resources6040056
7 Md. Hasan Ali, Akio Miyara, Keishi Kariya. “Numerical Optimization of Double Tube GHE for Ground Source Heat Pump”. International Journal of Sustainable and Green Energy. 2017, Vol. 6, No. 5, pp. 64-75. doi: 10.11648/j.ijrse.20170605.11
6 A. Miyara, K. Kariya, Md. H. Ali, S. B. Selamat, and Jalaluddin, “Heat transfer characteristics of various kinds of ground heat exchangers for ground source heat pump system”. AIP Conference Proceedings, 2017, Vol. 1788, Paper ID: 020001. 2017, American Institute of Physics, USA. https://doi.org/10.1063/1.4968249.
5 Md. Amzad Hossain, Md. Rasedul Islam, Md. Hasan Ali, and Mohammad Mashud, “Emission Control of DI Diesel Engine by Using Aqueous Salt Solution”. International Journal of Scientific & Engineering Research, 2013, Vol. 4, Issue 6, pp. 3009-3014.
4 Md. Hasan Ali, Mohammad Mashud, Md. Rowsonozzaman Rubel, and Rakibul Hossain Ahmad, “Biodiesel from Neem oil as an alternative fuel for Diesel engine”, Procedia Engineering, 2013, Vol. 56, pp. 625 – 630. https://doi.org/10.1016/j.proeng.2013.03.169.
3 Md. Abdullah Al Bari, Md. Hasan Ali, Mizanur Rahman, and Rakibul Hossain, “Prospect of Bio-diesel Production from soybean oil and sesame oil: An Alternative and Renewable Fuel for Diesel Engines” International Journal of Mechanical Engineering (IJME), 2012, Vol. 2, Issue 1, pp. 12-21.
2 Md. Hasan Ali, Mohammad Mashud, Abdullah Al Bari, and Muhammad Misbah-Ul Islam, “Numerical Solution for the Design of Minimum Length Supersonic Nozzle”, ARPN Journal of Engineering and Applied Sciences, 2012, Vol. 7, No. 5, pp. 605-612
1 Md. Hasan Ali, Mohammad Mashud, Md. Mahasin Ali, and H M Mehedi Rafique, “Passive Cooling System of a Building: A New Approach”, ISESCO Journal of Science and Technology, 2011, Vol. 7, No. 12, pp. 88-95.


National/International Conference

(Selected Papers)

22 Syed Abrar Sabab, Khaza Shahriar, Md. Hasan Ali, Mohammad Rezwan Hossain, “Building Energy Consumption Analysis of an University Academic Building: Modelling and Simulation”. 14th International Conference on Mechanical Engineering (ICME 2023), 18- 19 December 2023, Dhaka, Bangladesh, ID: 133.
21 Nushrat Jahan, Md. Hasan Ali, Nafisa Lubaba, Nahyan Ahnaf Pratik, “Comparison of Thermal Performance Analysis of Horizontal U-tube and Slinky Ground Heat Exchangers”. 14th International Conference on Mechanical Engineering (ICME 2023), 18- 19 December 2023, Dhaka, Bangladesh, ID: 76.
20 Md. Amir Hamza, Md. Sohag Hossain, Md. Hasan Ali, Omar Faruk Badhon, Ahbab Faiyaj Haque, “A Low-Cost Arduino-Based LPG Gas Leak Detector and Alarm System for Preventing Fire Accidents in Residential Buildings”. Energy Conference 2023 : National and Global Issues (ENCON 23), 14- 15 December 2023, Dhaka, Bangladesh, ID: 56.
19 Nafisa Lubaba, Nahyan Ahnaf Pratik, Nushrat Jahan, Md. Hasan Ali, “Investigating on Thermal Performance of U-tube Ground Heat Exchanger with Concrete Foundation Pile between U-legs”. 6th International Conference on Electrical Information and Communication Technology (EICT), 07~09 December, 2023, Khulna, Bangladesh, Paper ID: 339.
18 Tahir Mahmud, Nahyan Ahnaf Pratik, Nafisa Lubaba, Md. Hasan Ali, Akio Miyara, “Numerical Performance Investigation of a Flat Plate Solar Collector with an Upper Part U-Shape Riser”. 5th Euro-Mediterranean Conference for Environmental Integration (EMCEI-2023), 02 to 05 October 2023, University of Calabria, Rende (Cosenza), Italy, Paper ID: 510.
17 Nahyan Ahnaf Pratik, Nafisa Lubaba, Tahir Mahmud, Md. Hasan Ali, “Enhancing Thermal Performance and Cost-effectiveness of Compound Parabolic Solar Collectors: Exploring Novel Operational Configurations and Heat Transfer Optimization”. 5th Euro-Mediterranean Conference for Environmental Integration (EMCEI-2023), 02 to 05 October 2023, University of Calabria, Rende (Cosenza), Italy, Paper ID: 857.
16 Nushrat Jahan, Md. Hasan Ali, Akio Miyara, "Numerical Analysis of Thermal Performance of Various Types of Horizontal Ground Heat Exchangers". 5th Euro-Mediterranean Conference for Environmental Integration (EMCEI-2023), 02 to 05 October 2023, University of Calabria, Rende (Cosenza), Italy, Paper ID: 856.
15 Md. Mosiur Rahman, Imran Bhuiyan, Md. Hasan Ali, Mohammad Ariful Islam, Shuvo Paul, “Design, Fabrication and Performance Analysis of a Subsonic Open-Circuit Wind Tunnel”, 7th International Conference on Mechanical, Industrial and Energy Engineering (ICMIEE 2022), 2022, Khulna, Bangladesh, Paper ID: 187.
14 Nahid Hasan, Md. Hasan Ali, Nahyan Ahnaf Pratik, Nafisa Lubaba, “Modeling and Numerical Analysis of Spiral Tube Ground Heat Exchanger to Enhance the Performance”, International Conference on Mechanical, Manufacturing and Process Engineering (ICMMPE – 2022), 2022, Gazipur, Bangladesh, Paper ID 9253, pp: 355 - 360.
13 Nafisa Lubaba, Md. Hasan Ali, Nahid Hasan, Nahyan Ahnaf Pratik, “Numerical Investigation on Thermal Performance of Modified Vertical U-tube Ground Heat Exchanger”, International Conference on Mechanical, Manufacturing and Process Engineering (ICMMPE – 2022), 2022, Gazipur, Bangladesh, Paper ID 3673, pp: 117 - 122.
12 Nahyan Ahnaf Pratik, Md. Hasan Ali, Nafisa Lubaba, Nahid Hasan, “Numerical Performance Analysis of Solar Parabolic Dish Collector with Different Point Focusing Cavity Receiver for Optimizing the Thermal Performance”, 3rd International Conference on Innovations in Science, Engineering and Technology (ICISET), 2022, Chittagong, Bangladesh, Paper ID: 279, pp. 344-349.
11 Md. Hasan Ali, Salsuwanda Selamat, Keishi Kariya, and Akio Miyara, “Experimental performance estimations of horizontal ground heat exchangers for GSHP System”, 16th International Refrigeration and Air Conditioning Conference, July 11-14, 2016, Purdue, USA, ID: 2601, pp. 1-10.
10 Md. Hasan Ali, Salsuwanda Selamat, Akio Miyara, and Keishi Kariya, “Performance analysis of slinky loop horizontal ground heat exchangers”, 8th Asian Conference on Refrigeration and Air Conditioning (ACRA), May 15-17, 2016, Taipei, Taiwan, paper ID: 070.
9 Md. Hasan Ali, Kazi Md. Masum Billah, and Mohammad Mashud, “Construction and Performance Test of a Solar Powered Attic Ventilation System”, International Conference on Mechanical Engineering and Renewable Energy (ICMERE), May 01- 03, 2014, Chittagong, Bangladesh, Paper ID: ICMERE 2013-PI-069.
8 Ripon Kumar Saha, Md.Fashiar Rahamn, and Md. Hasan Ali, “Production of Biogas from Mesophilic Anaerobic Digestion of Kitchen Waste”, International Conference on Mechanical, Industrial and Energy Engineering, 01-02 February, 2013, Khulna, Bangladesh. Paper ID: MIE12-098.
7 A. N. M. M. Rahman, M. H. Ali, M. M. Hussain, M. K. Hasan, and T. B. Hussain, “Performance Comparison of Funnel Type and Bernard Type Solar Cooker”, 3rd International Conference on Addressing Climate Change for Sustainable Development through Up-Scaling Renewable Energy Technologies, October 12-14, 2011, Kathmandu, Nepal.
6 Md. Hasan Ali, A. N. M. Mizanur Rahman, Md. Fazle Rabbi, and Md. Mahmudul Islam. “Preservation of Wood by Full Cell Pressure Process”, International Conference on Mechanical, Industrial and Energy Engineering, 23-24 December, 2010, Khulna, Bangladesh. Paper ID: MIE10-87.
5 Md. Hasan Ali, A. N. M. Mizanur Rahman, and K. M. Z. Rahman, “Development and Performance Test of a Bread Box Solar Water Heater”, International Conference on Mechanical, Industrial and Energy Engineering, 23-24 December, 2010, Khulna, Bangladesh. Paper ID: MIE10-086.
4 Md. Hasan Ali, A. N. M. Mizanur Rahman, N. U. I. Hossain, and K. S. Islam, “Construction and Performance Test of Solid Desiccant Cooling System”, International Conference on Mechanical, Industrial and Energy Engineering, 23-24 December, 2010, Khulna, Bangladesh. Paper ID: MIE10-085.
3 Md. Syed Ali Molla, Md. Hasan Ali, Husnay Mobarak, and Md. Mominul Haque, “Experimental study on a program controlled direct gasoline fuel injection (DGI) system in SI engine for variable speed and load”, International Conference on Mechanical, Industrial and Energy Engineering, 23-24 December, 2010, Khulna, Bangladesh. Paper ID: MIE10-042.
2 Mohammad Mashud, Md. Hasan Ali, Prithiraj Sarker, and Ratry Dey, “Experimental Study & Comparison of Power Losses from Wind & Rolling Resistance between Train & Bus:, 13th Asian Congress of Fluid Mechanics, 17-21 December 2010, Dhaka, Bangladesh. Paper ID:189.
1 Mohammad Mashud, Md. Hasan Ali, Md. Roknuzzaman, and Asadullah Al Galib, “Biodiesel from Jatropha Oil as an Alternative Fuel for Diesel Engine” Proceedings of the International Conference on Mechanical Engineering, 26- 28 December 2009, Dhaka, Bangladesh, ID: ICME09-TH-06.